Firmware format
Firmware package
Section titled “Firmware package”The jx402_08 reference package is an outer AOTA containing a nested TEMP.bin AOTA. The stock package verifies at the container and file levels and rebuilds byte-for-byte. The seven extracted SDFS archives also rebuild byte-for-byte. This package supplies the application and resources. Bootloader, recovery and the boot-time partition table are outside the package.
uv run fwkit info dumps/binaries/firmware/JX402_w3pro_V1.0.1.77.binuv run fwkit verify dumps/binaries/firmware/JX402_w3pro_V1.0.1.77.binuv run fwkit unpack dumps/binaries/firmware/JX402_w3pro_V1.0.1.77.bin work/wp3-aotaRun these offline from the checkout after fetching the reference image. For the command reference see fwkit. Keep WP2 assumptions out of WP3 code unless the corresponding structures have been compared.
The reference package has no trailing A-GPS data. Do not require the Watch Pro 2 trailer when inspecting this build.
Application image
Section titled “Application image”| Field | Stock 1.0.1.77 |
|---|---|
| Format and architecture | ACTH, little-endian Thumb-2 |
| Load address | 0x10000000 |
| Vector table offset | 0x200 |
| Application size | 2,871,936 bytes |
| Initial stack pointer | 0x2ff9e340 |
| Reset vector | 0x10114b2d |
In Ghidra, import the extracted app as a raw binary using ARM:LE:32:Cortex at the load address above. File offset 0x200 maps to 0x10000200. Clear the Thumb bit when locating the reset instruction. The binary-analysis setup in the Ghidra guide is shared; its example function addresses are for Watch Pro 2.
Watch-face resources
Section titled “Watch-face resources”The reference package contains seven stock faces in res_d.bin. Their texture
formats, import workflow and rendering checks are covered in
Watch faces.